Axle Half Shaft Driveshaft Boot Repair Kit 240Z 260Z 280Z

Axle Half Shaft Driveshaft Boot Repair Kit 240Z 260Z 280Z

4.9
(762)
Write Review
More
$ 15.99
Add to Cart
In stock
Description

CV Joint Boot Rear Inner Axle Kit S30 S130 - 800-040 (). One new rear inner CV joint boot kit for 1970-83 Datsun 240Z/260Z/280Z/280ZX.

One new axle joint boot kit for 1970-83 Datsun 240Z/260Z/280Z/280ZX. Includes high quality rubber boot, clamps, & grease. This is a universal type boot which may require cutting to fit.


New fuel tank sending unit for 1970-1974 Datsun 240Z and 260Z as well as 75-76 280Z*.   Choose from OEM Nissan or aftermarket part.  If your fuel gauge is not working or working erratically, the fuel sender is most likely the problem. Installs in the front passenger side of the fuel tank. Removal of the tank should not be required to install the sender. Just be sure your gas tank is close to empty before removing the old sending unit.

1977-78 280Z uses the sending unit that drops in the top of the tank, 3 wire connector.

Aftermarket unit includes O-ring, OEM does not include O-ring.

*75-76 280Z has a 3 wire connector for the sending unit, the 240Z sender only uses 2 wires.  Use your solid yellow and black wire from the 280Z harness to connect to this sender.   Low fuel light (if applicable) may not function with this sender.  

Connector PT# 800-1124, O-ring PT# 200-409.


New OEM Genuine Nissan rubber inner shift boot. This rubber shift boot will fit 1972-78 Datsun 240Z, 260Z, and 280Z (not series 1). This inner shift boot fits on the metal floor tunnel which is right below the vinyl or leather shift boot. This rubber boot helps to keep out noise, fumes, and debris that can come in from underneath the car.

*See PT# 800-1233 for metal retainer plate for this boot.


New coolant thermostat in 160, 170, 180 or 195 degree. Will fit datsun 240Z, 260Z, 280Z, 280ZX and 510 1968-83. The 160 thermostat is the lowest temperature available. This thermostat will help your engine run cooler or great for racing engines. However in the winter this 160 thermostat may not allow your heater to blow hot air. A 180 is the best of both worlds and if you are in a year round cool climate the 195 is best.

Three styles available:

-Standard replacement 

-High Flow

-Fail Safe..   If thermostat fails it goes to full open instead of closing and overheating the engine. 


New OEM genuine Nissan shifter bushing kit. Includes all the parts needed to restore your shifter to its original tight feel. This kit will fit Datsun 240Z, 260Z, 280Z, and 280ZX, from Aug 1971 to 1983. Parts included are the shifter metal pin with both plastic bushings and the E clip, along with the shifter end cup bushing.  These parts are serviceable from the interior of the car, under the shift boot.  Choose from two different options.

* Individual parts are sold separately on the website.  


New OEM Genuine Nissan oil filter for Datsun 240Z, 260Z, 280Z, 280ZX and 510, 1969-83. Made in japan.

Axle Rubber Boot & Clamps Kit OEM Datsun 240Z 260Z 280Z New OEM Genuine Nissan axle boot & clamps set.

Axle Driveshaft Half Shaft Boot or Clamp OEM 240Z 260Z 280Z 510

New half shaft axle bolt. Will fit Datsun 240Z, 260Z and 280Z, 1970-78. These are bolts for the axle shaft to the outer stub axle at the wheel.

Axle Driveshaft Half Shaft Bolt Special 240Z 260Z 280Z

New OEM half shaft boot + bands for Datsun 240Z, 260Z & 280Z. NISSAN Genuine parts.

OEM half shaft boot + bands (240Z 260Z 280Z)

NOS (new old stock) pair of rear axle rubber boots with the necessary metal clamps. These fit 240z's, 260z's, and 280z's (manufactured up to 11/76).

Datsun 240Z 260Z 280Z(X) 510 Rear Axle Rubber Boots w/Clamps OEM NOS

Original Datsun 240Z 260Z 280Z Rear Axle Half Shaft for R200 Rear Differential

Motorsport Auto - The Z Store - MSA Aluminum Driveshaft, 70*-78 240Z-260Z- 280Z Coupe

These custom spacers are made to let you use stock 300zx turbo CV axels in any 240z 260z 280z with an R200 differential. These spacers are made

240z 260z 280z CV Axle conversion brackets for R200 differential uses Z31 300ZXT turbo shafts

240Z Restoration – Spannerhead

Custom Aluminum Driveshaft Propeller 240Z 260Z 280Z

Axle Half Shaft U Joint 240Z 260Z 280Z 280ZX 510