In the process of redoing a toolbox and I’m hoping to expedite this with the CNC. Previously I would lay the tools out, trace them with a sharpie and then use a Dremel with a router attachment to cut out the silhouette. I tried uploading the attached pictures into Inkscape and then doing “trace bitmap”, but it was nowhere near the outline I needed. Is there a way to take a picture of the layout, and create a carve path in ESTLCAM? I realize that some tools created a reflection in the picture
Tool settings for flat tipped v-carve bit - EstlCAM - V1 Engineering Forum
08. Custom Stencil Buffer - Elysia-ff/UE4-Custom_Stencil_Tutorial GitHub Wiki
Dave Lers : Workshop : CNC : Estlcam : Carving
Carving Logos Help - Advice - V1 Engineering Forum
Create silhouette for carving on Kaizen foam - EstlCAM - V1 Engineering Forum
Hello Pumpkin - Thoughts on carve quality? - Things You've Made - V1 Engineering Forum
EstlCam carve edges not smooth - Troubleshooting - V1 Engineering Forum
Estlcam tool list for v1engineering variety pack - Advice - V1 Engineering Forum
Estlcam v-carve inlay? - Software / Firmware - V1 Engineering Forum
Kaizen Inserts (@kaizen_inserts) • Instagram photos and videos